Power UNITS FOR LIFT TABLE one
General Description
This electrical power unit is created exclusively for the tiny lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit continues to be widely employed during the marketplace of logistic gadgets including minifork lift, scissors lift and ariel working platforms. The lower-ing movement is managed through the solenoid valve with all the speed controlled by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Standard Description
This electrical power unit is designed exclusively for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as pace managed from the adjustable needle valve. When the lift rises to a high positoin, however the power supply is minimize, the lowering movement is controlled by the guide override perform.
Energy UNITS FOR LIFT TABLE three
Standard Description
This power unit is intended exclusively for that large lift table, Consisting of extremely effecient gear pump, AC motor, 
multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve and also the speed managed by a stress compensated movement handle valve.
Energy UNITS FOR LIFT TABLE four
General Description
This power unit is made solely for that big lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as the velocity controlled through the adjustable needle valve. When the lift rises to a higher positoin, but the energy supply is reduce, the lowering motion is controlled through the manual override perform.
Unique Notes
1. This energy unit is of S3 duty cycle, which can only get the job done intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean each of the hydraulic elements concerned prior to set up of the energy unit.
3. Viscosity on the oil shoud be 15~46 cst,which really should also be clean and free of charge of impurities.N46 hydraulic oil is advised.
4. Oil transforming is required just after the initial one hundred operation hours,afterwards as soon as every 3000 hours.
five. The energy unit shown is made to be mounted vertically.
