SMR Gearbox Set up
Satisfactory performance depends upon proper installation. lubrication and maintenance. for that reason it’s important that the directions while in the set up and maintenance leaflet. supplied with each and every gearbox. are followed very carefully. a number of the essential aspects of belt and torque-arm set up are listed under.
1. Install pulley on gearbox input shaft as near on the reducer probable, and mount reducer on driven shaft as shut to bearing as sensible. failure to complete this may trigger excess loads in the input shaft bearings and output bearings and could trigger their premature failure.
2. Install motor and wedge belt drive with all the belt pull at approximately 90° to the center line among driven and input shafts. this may permit tensioning of the wedge belt drive with all the torque arm which ought to ideally be in stress. if output hub runs anti-clockwise. torque arm needs to be positioned the proper.
three. lnstall torque-arm fulcrum on a rigid support to ensure that the torque-arm is going to be at roughly correct angles to the center line through the driven shaft along with the torque arm situation bolt. 
make sure there is certainly ample consider up during the turnbuckle for belt tension adjustment.
Hold near.
Bell drive might be located in any practical postion. in the event the torque arm should be to be utilised to tighten the belts, the drive really should be at about tight angle to your line concerning the input and output shafts.
Bell drive may be situated for the suitable if sought after.
If output hub rotates clock-wise. position belt drive and torque arm in opposite path to that shown from the illustration.
Torque arm and belt get up.
Torque arm could possibly be mounted on the right if preferred.
